AMT Datasouth Fastmark 403 Driver
View full AMT Datasouth Fastmark TT specs on CNET. AMT Datasouth Fastmark ›Printers and MFPs›AMT Datasouth TT. Fastmark TT Std 2 ips, dpi, 4" wide DT/TT, " media roll, V, For your low to moderate printing applications, the Fastmark Series offers all the FMTT and FMTT: Direct Thermal AMT Datasouth International.
|Supported systems:||Windows 2K, Windows XP, Windows Vista, Windows Vista 64 bit, Windows 7, Windows 7 64 bit, Windows 8, Windows 8 64 bit, Windows 10|
|Price:||Free* [*Free Registration Required]|
AMT Datasouth Fastmark 403 Driver
Fastmark Thermal Printers
The first time you use Fastmark and each time a new type of media is loaded length, gap, color, etc. Load the media to be calibrated, power on the printer while holding the FEED key, release as soon as media starts feeding, then cycle power after the feed stops. Now each time the AMT Datasouth Fastmark 403 key is pressed one form should feed. How do I tell which emulation and firmware revision is loaded in my printer?
Fastmark Thermal Printers AMT Datasouth
Power on holding the FEED key. Continue to hold until feeding stops then release, after a pause the configuration report will print. Press the FEED key to exit this mode.
AMT Datasouth Fastmark 403 can I fix this? This allows all data sent to the printer to be displayed as HEX values which is useful debugging communication and programming issues. To exit this mode press the FEED key or cycle power on the printer. After I load media, sometimes it does not feed properly and printing is in the wrong position.
How do I correct this? First, if AMT Datasouth Fastmark 403 have just loaded a new roll, make sure you shut the top cover before printing or feeding media. Also ensure the media is loaded according to the users manual and you have performed a media calibration. Which emulation needs to be loaded in my printer to use Windows drivers?
The supplied Windows drivers works with all versions of the printer regardless of the AMT Datasouth Fastmark 403 loaded. If drivers from other sources are used make sure you match the driver to the emulation loaded in the printer as follows: My printer is acting up, how do I reset it to factory defaults? The printer will then automatically perform a label calibration test.
How do I change the serial port baud rate? As shipped from the factory the baud rate is set to ,8,1,N. If in question use the factory reset method to reset the printer back to this condition.
Drivers AMT Datasouth
Changing the baud rate is possible through software commands depending on emulation: Changes to baud rate are stored in NVM. Can I use thermal transfer models with direct thermal media? If so do I have to set anything on the printer? AMT Datasouth Fastmark 403 thermal media can be used in thermal transfer models. To do so the printer must be set up for direct thermal mode.
AMT Datasouth Fastmark Argecy
Under options, un-check the Ribbon selection. The emulation is PPLA as shipped from the factory. If there is any question do a configuration print to determine installed emulation.
After making sure all options are set, either send the blank label to the printer by AMT Datasouth Fastmark 403 or save to a file using the save to file check box. In this case the file can be used to configure multiple printers by using a DOS copy command.
Also, if you are writing the program to send data to the printer, make sure the commands are included in your data stream. Using the save to file option under XBar is a good way to see the required programming strings.
I plan on programming my label format on my host computer. What is the best way to determine what commands need to be sent to the printer? The best way is to use the included XBar program.