ECS P55H-A (V1.0) Driver
Download the latest ECS Elitegroup Socket P55 P55H-A2 (V) device drivers (Official and Certified). ECS Elitegroup Socket P55 P55H-A2 (V). SATA -connectors: 6 x 7pin Serial ATA - 6 devices - RAID 0 / RAID 1 / RAID 10 / RAID 5 JMicron JMB ATA -connectors: 1 x 40pin IDC - 2 devices. P55H-A, ECS Black Series motherboard, features Intel New Nehalem 2-Chip solution, Lynnfield CPU and P55(Ibex peak) chipset, supporting DDR3
|Supported systems:||ALL Windows 32x/64x|
|Price:||Free* [*Free Registration Required]|
ECS P55H-A (V1.0) Driver
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television ECS P55H-A (V1.0), which can be determined ECS P55H-A (V1.0) turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Operation is subject to the following conditions: AbouttheManual The manual consists of the following: Describes features of the motherboard.
Go to H page 1 Describes installation of motherboard components.
P55 is a single-chip, highly integrated, high performance Hyper-Threading peripheral controller, unmatched by any other single chip-device controller. The motherboard uses an LGA type of socket that carries the following ECS P55H-A (V1.0) Some hardware specifications and software items are subject to change without prior notice.
EliteGroup Computer (ECS) P55H-A Ultra (V) (DDRMHz) Memory EliteGroup Computer O/P Series
FDD1 Floppy disk drive connector 6. COM Onboard serial port header PCI1 bit add-on card slot The next chapter explains how to install the motherboard. Do not bend circuit boards Choosing a Computer Case There are many types of computer cases on the market. The motherboard complies ECS P55H-A (V1.0) the specifications for the micro ATX system case.
ECS P55H-A (V1.0) features on the motherboard are implemented by cabling connectors on the motherboard to indica- tors and switches on the system case. Make sure that your case supports all the features required.
- ECS P55H-A User Manual
- ECS P55H-A SLI(V) Motherboard download instruction manual pdf
- ECS P55H-A Manual: Front Panel Header
- ECS P55H-CM (V1.0) manual
- ECS P55H-AK (V1.0) Bios 08/04/2010 For Windows All
This motherboard carries a micro ATX form factor of x mm. Choose a case that accommodates this form factor.
Installing the Motherboard in a Case Refer to the following illustration and instructions for installing the motherboard in a case. Most system cases have mounting brackets installed in the case, which correspond the holes in the motherboard. Place the motherboard over the mounting brackets and secure the motherboard onto the mounting ECS P55H-A (V1.0) with screws.
Setting Jumpers Use the motherboard jumpers to set system ECS P55H-A (V1.0) options. Jumpers with more than one pin are numbered. When setting the jumpers, ensure that the jumper caps are placed on the correct pins.
The ECS P55H-A (V1.0) show a 2-pin jumper. If you remove the jumper cap, or place the jumper cap on just one pin, the jumper is OPEN. This illustration shows a 3-pin jumper.
Pin 1 ECS P55H-A (V1.0) labeled. When installing a CPU heatsink and cooling fan make sure that you DO NOT scratch the motherboard or any of the surface-mount resis- tors with the clip of the cooling fan.